Here we have assembled the tools that make the installation of our product both accurate and complete. We do not sell wire that is found at your local hardware store. We do recommend using 20 or 22 gage stranded wire for the best results. No two projects are the same. With this in mind, we have shown only one approach for wiring our product. In reality there are numerous ways and you will have to determine the best approach for you your project.   Our Drill Kit insures code compliance, exact hole to hole spacing, and eliminates the need to mark each individual hole. Our Forstner bit is custom ground fit to our balusters to avoid tearing of the material. Using a simple spade bit is not recommended for our balusters. Our wire connectors allow the wires to be connected without stripping by a simple snap of the connector with pliers. They are silicone filled making sure moisture is never an issue.